How to Write a DBQ in APUSH in FIVE EASY STEPS Essays (292 words)

How to Write a DBQ in APUSH in FIVE EASY STEPS Essays (292 words) How to Write a DBQ in APUSH in FIVE EASY STEPS Read the prompt Brainstorm OI using categories Read the documents and place in the categories Write thesis Write essay STEP ONE: Read the questions Read the question. (What am I supposed to answer in my essay?) Pay attention to verbs! **Review IB terms on the board. STEP TWO: Brainstorm Similar to what we do for the FRQ, we brainstorm for the DBQ FIRST. You are required to demonstrate a thorough knowledge of the TOPIC not just the documents! You can use the pre-write structure. (T-chart, venn diagram, etc.) STEP THREE Read the documents. Its a good idea to take little notes in the margins about the main idea of each. That way you dont spend time later re-reading each one. Be careful to pay attention to APPARTS stuff. Underline author/date to save time. As you go, jot down which category each doc goes into. STEP FOUR: Thesis Use the formula to guide you. (X, However A, B,C therefore, Y) You need to do TWO things in a thesis: Say what you are going to write about (this is where you answer the question- Y) Say how youre going to answer the question (this is where you set up your answer- ABC) STEP FIVE: Write the body Each paragraph should have a category. NEVER write chronologically. You should answer the question using the documents AND outside information DONT RELY ON THE DOCS ALONE! Avoid direct quotes. If you do use them, you must apply them to the prompt! Write a conclusion if you have time. PRACTICE! Use the 1993 DBQ to practice the steps 1-4. You are not writing the full essay so ignore five. Remember to brainstorm for OI first then look at the docs.